Measuring

Our on-site consultant will arrive on the job site using the latest digital tools to make accurate measurements of the areas where the material will be installed.

Cabinet Placement & Fastening

The cabinets must be set and fastened into their permanent location at the time of the templating. The cabinets must be straight and level with one another.

Cabinets/Sub-Tops

For new cabinets, please specify to the cabinet-maker which material you are planning to use as the countertop. This will help them ensure that the cabinets are straight, level, fastened & shimmed properly, to provide the proper support for your material. If you plan to use your current cabinets existing countertops must be removed prior to the installation process. Although not normally done by our technicians, arrangements can be made prior to installation for Elegant Creations to remove your current tops. Please have your cabinetry inspected, properly fastened and shimmed before the templating process. This will insure a reliable support & a good installation of your new countertop.

Sinks

All sinks and faucets must be at the job site at the time of templating. This will allow us to go over faucet placement, as well as allow us to bring your sink & faucet back with us to ensure the proper fit.

Stove Tops

If you choose to have a cooktop or lip-over range, it is important that the appliance is at the job site when our technician is templating. This unit fits very closely to the cutout, therefore it must be measured very accurately. It is however the responsibility of the homeowner that all appliances are the right sizes for the cabinetry.